Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does a Garage Door Cost in Park Slope?
Garage door work in Park Slope typically runs $150 – $600 for repairs, with the most common job being a single broken spring at $180 – $340. A full new door installation runs higher, typically $700 – $2,200. Those are estimated ranges for this market, not a quote: the written estimate we give you after looking at the door is what sets the final price.
What makes Park Slope different from a lot of other places is the housing stock. The brownstones and row houses around here have older garages, often with the original heavy wood doors and the low-headroom track setups that were common in buildings from the 1890s through the 1930s. That changes the math. A door that opens fine on a flat suburban driveway can be fighting its own weight and the tight clearances in a Park Slope garage, and that stress shows up on springs, cables and openers first.
Our technicians have up to 8 years of experience on residential doors, and we work on eight major brands: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor. If your door is older, or your opener is a newer myQ unit, the parts and the calibration are different. We keep that in mind before we quote.
Garage Door Cost Breakdown (2026)
Here’s what each service typically costs in Park Slope this year. These are estimates for a standard residential job. Your door’s condition, whether it’s a single panel or a double, and the brand all move the number up or down.
| Service | Typical Estimated Range |
|---|---|
| Garage door repair (general) | $150 – $600 |
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
One note on springs: the spring range is for a single spring. Most doors have a matched pair, and since they wear at the same rate, they’re usually replaced together. That means a pair costs about twice the single-spring range. We’ll tell you plainly if we think you need both or just one.
What pushes a bill toward the top of a range? Springs on a heavy solid-wood door, track that’s been bent out of true, an opener that won’t respond and turns out to be a board failure rather than a remote problem. What keeps it at the low end? A straight spring swap on a standard sectional door, a roller set, a cable that failed cleanly without taking the drums with it.
What Affects Garage Door Pricing in Park Slope
Park Slope is a specific market, and the price you see here reflects that. A few things drive the number more than others.
- Older housing stock and heavy doors. A lot of the garages in the blocks between Fifth Avenue and Prospect Park were built for solid wood doors that weigh far more than today’s steel panels. Heavier doors demand more from springs and openers, and a replacement door has to match the existing headroom and track. That can mean more labor, and sometimes a torsion conversion instead of a straight extension-spring swap.
- Low headroom and tight clearances. Brownstone garages and converted carriage houses often have low ceilings and shallow tracks. Not every off-the-shelf opener or door fits. Measuring twice matters more here than on a new build, and a job that needs a low-clearance setup can sit above the midpoint of the range.
- Which brand you have. Services for LiftMaster and Chamberlain openers are common and parts are easy to source. An older Wayne Dalton or a Craftsman system can need specific components that change the number. We work on all eight of the major brands, so the brand itself won’t send you to a second contractor.
- Whether it’s an emergency. A door that won’t close and leaves the garage exposed is a security problem, not something to leave until later. We offer emergency garage door service for exactly this. Emergency jobs don’t automatically cost more, but they can affect scheduling.
- Condition of the rest of the system. A broken spring rarely fails alone. If the cables are frayed too, or the rollers are flat-spotted, you’re paying for more than one line item. That’s why a general garage door repair range runs wider than a single-spring job.
- Panel and color availability. Matching a single bent panel to an existing door is easier when the door is a current Clopay or Amarr model. A discontinued door can mean repairing the panel rather than replacing it, or replacing more of the door than you’d planned.
How to Save on Garage Door Costs
Most of the savings on a garage door come from acting early and being honest about the condition of the whole system. Here’s what actually helps.
- Get the estimate in writing before work starts. A written estimate is the price, and it also tells you what’s included. Free estimates cost nothing and make comparing easier. Call (855) 709-6141 and we’ll come out and give you one.
- Replace springs in pairs if they’re the same age. It sounds like more money up front, but replacing one spring on a pair that went in together usually means paying for a second visit soon after. A pair costs about twice the single range, and it’s often the cheaper path over the long run.
- Don’t skip a small repair. A noisy roller or a door that’s slightly off its track is cheap to fix now (roller replacement runs $110 – $220). Left alone, it stresses the springs and the opener, and the bill grows.
- Know when repair beats replacement. If the door panels are sound and the frame is solid, repairing the springs, cables and opener is almost always cheaper than a new door. A new installation ($700 – $2,200) makes sense when the door itself is failing, not just its hardware.
- Ask about the opener before replacing it. An opener repair ($120 – $320) is worth considering before a full opener installation ($250 – $550). A lot of “dead” openers are a gear, a board or a remote pairing issue, not a dead motor.
- Bundle the visit. If the tech is already out for a spring repair, a track realignment ($120 – $240) or a fresh set of rollers costs less than a second trip.
If you’re weighing repair against replacement, our guide to new installation covers what a full install involves, and if a door fails on a Saturday, call us and we’ll book you for Sunday, since we’re closed Saturdays and open Sunday through Friday, 7am to 7pm.
FAQs – Garage Door Cost in Park Slope
How much does a garage door repair cost in Park Slope?
Garage door repair in Park Slope typically runs $150 – $600, with most jobs landing mid-range. Spring repair on one spring is $180 – $340, cable repair $130 – $250, and opener repair $120 – $320. Call (855) 709-6141 for an exact quote – estimates are free.
Is it cheaper to repair or replace a garage door?
Repair is almost always cheaper when the door itself is sound; a spring or opener fix at $120 – $340 beats a new installation at $700 – $2,200 every time. Replacement makes sense when panels are rotting, the frame is failing, or the door is beyond safe repair. Call (855) 709-6141 and we’ll give you a straight answer after seeing the door.
How much does a new garage door cost in Park Slope?
A new garage door installation in Park Slope typically costs $700 – $2,200 depending on door size, material and whether the track and opener need updating. Older low-headroom garages can sit near the top of that range. Call (855) 709-6141 for a free written estimate.
Can you come today?
Yes, same-day service is available for many jobs. We’re open 7am to 7pm Sunday through Friday and closed Saturday. For a door that won’t close or a snapped spring, call (855) 709-6141 first thing and we’ll arrange the earliest slot.
Why does a spring replacement cost more for a pair?
A pair costs about twice the single-spring range because two springs are replaced, and they’re usually replaced together to keep the door balanced. One spring typically runs $180 – $340, so a matched pair lands near the top of that doubled figure. Call (855) 709-6141 to confirm which your door needs.
Get a Free Estimate in Park Slope
If your door is stuck, your opener is dead, or you’re trying to decide between a repair and a new door, we can help. One call covers repair, opener work, springs and installation, and we work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor systems. For garage door repair Sunset Park and Park Slope homeowners, we keep it straightforward: we look, we explain, we quote in writing, and the written estimate sets the price. Call (855) 709-6141 for a free estimate today.
Pricing reflects the Park Slope market as of 2026. Garage Door Repair Sunset Park offers free estimates – call (855) 709-6141.
What Our Customers Say
"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Dale Walsh"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Allen Tran"Spring snapped at six in the morning with my car sealed inside and me due at work. Somebody was here by eight thirty and had it fixed that morning. Door's quieter now than it was before it broke."
- Cedric Mosley